Having gone down the FPGA part selection route and not the board selection route leaves the ZYNQ7 Processing System
configured using its default settings.
The Zedboard settings applied by selecting the Apply Board Preset
(if it were present) are as shown below. Note there are some very important settings that MUST be applied, to name a few, the Bank 1 voltage and the DDR configuration. These settings can be applied through the ZYNQ7 Processing System
re-customization dialog but this time around the script below shall be used to configure the PS in exactly the same way as if the Zedboard presets were applied.
Save the zedboard_presets.tcl
script into /home/steve/projects/common/fw
and run the script from the Tcl Console
using source /home/steve/projects/common/fw/zedboard_presets.tcl
After execution of the script the ZYNQ7 Processing System
should reflect the applied changes.